FAIL-SAFE CHART
System information · Vehicles built Jul 2007 – Jul 2011
Versions by build date: Jul 2007 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
| FAIL SAFE OPERATION |
- If there is a problem with any sensor signals or hydraulic brake booster systems, the skid control ECU prohibits the power supply to the actuator in the hydraulic brake booster and informs the ECM of VSC system failure.
The hydraulic brake booster turns off solenoids and the ECM shuts off the VSC control (traction control signal) from the skid control ECU accordingly, the result of which is as if the ABS, TRC and VSC systems were not installed.
ABS control is prohibited, but EBD control continues as far as possible. If EBD control is impossible, the BRAKE warning light comes on to warn the driver (Click here).
- If system components have any malfunctions before starting control, the operation stops immediately.
If system components have any malfunctions during control, the control stops gradually so as not to trigger a sudden change in vehicle conditions.
If it is impossible to control the systems, the warning light comes on to inform the driver of the malfunction in the systems (Click here).
- HINT:
- If the ABS, BA, TRC, A-TRAC and VSC systems malfunction, the brake system will operate normally without ABS, BA, TRC and VSC.
- If the hydraulic brake booster malfunctions, a gradual loss of brake performance is expected, and ABS, BA, TRC, A-TRAC and VSC system controls are prohibited.
- If the ABS, BA, TRC, A-TRAC and VSC systems malfunction, the brake system will operate normally without ABS, BA, TRC and VSC.
ABS, EBD and BA systems:
- HINT:
- If the ABS, BA or EBD system malfunctions, the following controls are prohibited as shown in the table below.
Malfunction Area
Fail-Safe Operation
ABS system
ABS, BA, TRC, A-TRAC and VSC control prohibited
BA system
ABS, BA, TRC, A-TRAC and VSC control prohibited
EBD system
ABS, BA, EBD, TRC, A-TRAC, VSC and EBD control prohibited
TRC, A-TRAC and VSC systems:
- HINT:
- If TRC, A-TRAC and/or VSC malfunction, the following controls are prohibited as shown in the table below.
Malfunction Area
Fail-Safe Operation
Engine control system
(TRC, A-TRAC and VSC systems)
Before control: Disables control
During control: Uses only brakes to effect control
Brake control system
(VSC system)
Before control Disables control
During control Uses only brakes to effect control
Brake control system
(TRC and A-TRAC systems)
Before control: Disables control
During control: Disables control (by gradually ending control)
| SYSTEM TEMPERATURE PROTECTION OPERATION |
| System |
Indicator Condition |
| TRC or A-TRAC system |
SLIP indicator light comes on |