2011-2016 FJ Cruiser · Service Manual BRAKE

FAIL-SAFE CHART

System information · Vehicles built from Aug 2012

Versions by build date: Jul 2007 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012


FAIL SAFE OPERATION
  1. If there is a problem with any sensor signals or hydraulic brake booster systems, the skid control ECU (master cylinder solenoid) prohibits the power supply to the actuator in the hydraulic brake booster and informs the ECM of VSC system failure.
    The hydraulic brake booster turns off solenoids and the ECM shuts off the VSC control (traction control signal) from the skid control ECU (master cylinder solenoid) accordingly, the result of which is as if the ABS, TRC and VSC systems were not installed.
    ABS control is prohibited, but EBD control continues as far as possible. If EBD control is impossible, the BRAKE warning light comes on to warn the driver (Click here).
  2. If system components have any malfunctions before starting control, the operation stops immediately.
    If system components have any malfunctions during control, the control stops gradually so as not to trigger a sudden change in vehicle conditions.
    If it is impossible to control the systems, the warning light comes on to inform the driver of the malfunction in the systems (Click here).

HINT:
  1. If the ABS, BA, TRC, A-TRAC, VSC or crawl control systems malfunction, the brake system will operate normally without ABS, BA, TRC, A-TRAC, VSC or crawl control system controls.
  2. If the hydraulic brake booster malfunctions, a gradual loss of brake performance is expected, and ABS, BA, TRC, A-TRAC, VSC and crawl control system controls are prohibited.

  1. ABS, EBD and BA systems:

    HINT:
    If the ABS, BA or EBD system malfunctions, the following controls are prohibited as shown in the table below.

    Malfunction Area
    Fail-Safe Operation
    ABS system
    ABS, BA, TRC, A-TRAC, VSC, and crawl control prohibited
    BA system
    ABS, BA, TRC, A-TRAC, VSC , and crawl control prohibited
    EBD system
    ABS, BA, EBD, TRC, A-TRAC, VSC, and crawl control prohibited

  2. TRC, A-TRAC, VSC, and crawl control systems:

    HINT:
    If TRC, A-TRAC, VSC and/or crawl control malfunction, the following controls are prohibited as shown in the table below.

    Malfunction Area
    Fail-Safe Operation
    Engine control system
    (TRC and A-TRAC systems)
    Before control: Disables control
    During control: Uses only brakes to effect control
    Brake control system
    (VSC system)
    Before control Disables control
    During control Uses only brakes to effect control
    Brake control system
    (TRC, A-TRAC, and crawl control systems)
    Before control: Disables control
    During control: Disables control (by gradually ending control)


SYSTEM TEMPERATURE PROTECTION OPERATION
If the TRC, A-TRAC or crawl control system has been used constantly for a long time, the temperature of the hydraulic brake booster may increase excessively. If the temperature increases excessively, the skid control buzzer sounds intermittently. If the temperature increases further, the skid control buzzer sounds for 3 seconds repeatedly and the indicator light either comes on or blinks.
System
Indicator Condition
TRC or A-TRAC system
SLIP indicator light comes on
Crawl control
SLIP indicator light comes on
Crawl indicator light blinks and then turns off
← FAIL-SAFE CHART (Aug 2011 – Jul 2012)DATA LIST / ACTIVE TEST (Jul 2007 – Oct 2010) →