2011-2016 FJ Cruiser · Service Manual BRAKE

CHECK FOR INTERMITTENT PROBLEMS

Troubleshooting · Vehicles built from Jul 2007


DESCRIPTION

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected through the ECU data monitor function of the intelligent tester.

  1. Turn the ignition switch off and connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON. Follow the on-screen directions on the intelligent tester to display the Data List and select areas which should be monitored for momentary interruptions.

    HINT:
    A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

    Tester Display
    Measurement Item / Range
    Normal Condition
    Diagnostic Note
    FR Speed Open
    FR speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    FL Speed Open
    FL speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    RR Speed Open
    RR speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    RL Speed Open
    RL speed sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    EFI Open
    EFI communication open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Yaw Rate Open
    Yaw rate sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Deceleration Open
    Deceleration sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Steering Open
    Steering angle sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -
    Accumulator Open
    Accumulator pressure sensor open detection / OPN_DET or NORMAL
    OPN_DET : Momentary interruption
    NORMAL : Normal
    -

    HINT:

    1. C106657E21
      If the intelligent tester status remains open, check the continuity between the ECU and the sensors, or between ECUs.
    2. The OPEN display on the intelligent tester remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.

  3. F047126
    While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

    OK:
    OPEN-screen display does not change.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Jul 2007)CALIBRATION (Jul 2007 – Jul 2008) →