2011-2016 FJ Cruiser · Service Manual BRAKE

FREEZE FRAME DATA

Troubleshooting · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


HINT:
  1. Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
  2. The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to ON since the last time the ABS was activated. However, if the vehicle was stopped or at low speed (7 km/h (4.3 mph) or less), or if a DTC is detected, the skid control ECU will not count the number after that.
  3. Freeze frame data at the time the ABS operates: The skid control ECU stores and updates the data whenever the ABS system operates. When the ECU stores data at the time a DTC is detected, the data stored when the ABS operated is erased.
  4. Freeze frame data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Check the freeze frame data by following the prompts on the intelligent tester display.

Tester Display
Measurement Item
Reference Value
Freeze DTC
Freeze DTC
min.: 0, max.: 65535
Stop Light SW
Stop light switch signal
ON: Stop light switch ON
OFF: Stop light switch OFF
VSC/TRC OFF SW
VSC OFF switch signal
ON: VSC OFF SW ON
OFF: VSC OFF SW OFF
Shift Lever Position
Shift lever position
FAIL
P,N
R
D
4
3
2
L
Operated System
System status
ABS: ABS activated
VSC/TRC: VSC/TRC activated
BA: BA activated
FAIL SF: Fail safe mode activated
NO SYS: No system activated
Number of IG ON
Number of operations turning ignition switch ON since freeze frame data stored
0 to 31
Vehicle Speed
Wheel speed sensor reading
Speed indicated on speedometer
Steering Angle Sensor
Steering sensor reading
Left turn: Increase
Right turn: Drop (Deceleration)
Yaw Rate Sensor
Yaw rate angle sensor reading
-128 to 127
Master Cylinder Sensor1
Master cylinder pressure sensor reading
Brake pedal released: 0.3 to 0.9 V
Brake pedal depressed: 0.8 to 4.5 V
Master Cylinder Grade
Master cylinder pressure sensor change
-30 to 225 MPa/s
Right And Left G
Right and left G (Yaw Rate)
-1.869 to 1.869
Back And Forth G
Back and forth G (Deceleration)
-1.869 to 1.869
FR Wheel Direction
Front right wheel direction
Back: Wheel direction back
Forward: Wheel direction forward
FL Wheel Direction
Front left wheel direction
Back: Wheel direction back
Forward: Wheel direction forward
RR Wheel Direction
Rear right wheel direction
Back: Wheel direction back
Forward: Wheel direction forward
RL Wheel Direction
Rear left wheel direction
Back: Wheel direction back
Forward: Wheel direction forward
Buzzer
VSC buzzer signal
ON: VSC buzzer ON
OFF: VSC buzzer OFF
Reservoir Warning SW
Reservoir level warning switch signal
ON: Reservoir level warning switch ON
OFF: Reservoir level warning switch OFF
Parking Brake SW
Parking brake switch signal
ON: Parking brake switch ON
OFF: Parking brake switch OFF
← DTC CHECK / CLEAR (from Aug 2012)FREEZE FRAME DATA (from Nov 2010) →