2011-2016 FJ Cruiser · Service Manual BRAKE

TS and CG Terminal Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

In sensor check mode, malfunctions of the speed sensor that cannot be detected when the vehicle is stopped are detected while driving.
Transition to the sensor check mode can be performed by connecting terminals TS and CG of the DLC3 and turning the ignition switch from OFF to ON.

WIRING DIAGRAM

C164952E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. INSPECT DLC3 TERMINAL VOLTAGE (TS)

  1. F100115E44
    Turn the ignition switch to ON.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Specified Condition
    E1-12 (TS) - E1-4 (CG)
    11 to 14 V



OK
REPLACE MASTER CYLINDER SOLENOID (Click here)
NG


2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3)

  1. C138450E02
    Disconnect the skid control ECU connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified condition
    A4-24 (TS) - E1-12 (TS)
    Below 1 Ω
    A4-24 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (BODY GROUND - DLC3)

  1. F100115E43
    Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified condition
    E1 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← TC and CG Terminal Circuit (from Aug 2012)TS and CG Terminal Circuit (Nov 2010 – Jul 2012) →