2011-2016 FJ Cruiser · Service Manual TRANSMISSION

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Dec 2007 – Jul 2009

Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 from Aug 2009


CHECK DTC
DTCs which are stored in the ECM can be displayed with a intelligent tester.
The tester can display pending DTCs and current DTCs. Some DTCs are not stored if the ECM does not detect a malfunction during consecutive driving cycles. However, malfunctions detected during a single driving cycle are stored as pending DTCs.
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester ON.

  4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  5. Confirm the DTCs and freeze frame data and then write them down.

  6. Confirm the details of the DTCs (Click here).


CLEAR DTC
  1. When using a intelligent tester:

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the tester ON.

    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    5. Erase the DTCs.

  2. C130129E01
    When not using a intelligent tester:

    1. Disconnect the battery terminal or remove the EFI and ETCS fuses from the No. 2 engine room relay block for 60 seconds or more. However, if you disconnect the battery terminal, perform the "INITIALIZATION" procedure (Click here).

← DTC CHECK / CLEAR (Jul 2007 – Nov 2007)DTC CHECK / CLEAR (from Aug 2009) →