CHECK MODE PROCEDURE
Troubleshooting · Vehicles built from Jul 2007
| DESCRIPTION |
| CHECK MODE PROCEDURE |
Ensure the following conditions:
Battery positive voltage 11 V or more
Throttle valve fully closed
Transmission in the P or N position
A/C switched off
Turn the ignition switch to OFF.
Connect a intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menus: Utility / Check Mode.
Change the ECM to check mode. Make sure the MIL flashes as shown in the illustration.

- NOTICE:
- All recorded DTCs and freeze frame data will be erased if: 1) the intelligent tester is used to change the ECM from normal mode to check mode or vice-versa; or 2) during check mode, the ignition switch is turned from ON to ACC or LOCK.
- Before entering check mode, make notes of the DTCs and freeze frame data.
Start the engine. The MIL should turn off after the engine starts.
Perform "MONITOR DRIVE PATTERN" for the ECT test (Click here).
(Or, simulate the conditions of the malfunction described by the customer).After simulating the malfunction conditions, use the intelligent tester diagnosis selector to check the DTC and freeze frame data.