2011-2016 FJ Cruiser · Service Manual TRANSMISSION

HYDRAULIC TEST

Troubleshooting · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010


PERFORM HYDRAULIC TEST
G020657E01
  1. Measure the line pressure.

    NOTICE:
    1. Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature of 50° to 80°C (122° to 176°F).
    2. The line pressure test should always be carried out in pairs. One technician should observe the condition of the wheels or wheel stoppers outside the vehicle while the other is doing the test.
    3. Be careful to prevent the SST hose from interfering with the exhaust pipe.
    4. This check must be conducted after checking and adjusting the engine.
    5. Perform with the A/C OFF.
    6. Do not conduct stall tests for longer than 5 seconds continuously.


    1. Warm up the ATF.

    2. Lift the vehicle up.

    3. Remove the test plug on the transmission case center right side and connect SST.

      SST
      09992-00095   (09992-00231, 09992-00271)

    4. Fully apply the parking brake and chock the 4 wheels.

    5. Start the engine and check the idling speed.

    6. Keep your left foot pressing firmly on the brake pedal and shift into the D position.

    7. Measure the line pressure while the engine is idling.

    8. Depress the accelerator pedal all the way down. Quickly read the highest line pressure when the engine speed reaches the stall speed.

    9. In the same manner, do the test in the R position.

      Specified line pressure:
      Condition
      D position
      R position
      Idling
      356 to 426 kPa
      (3.6 to 4.3 kgf/cm2 , 52 to 62 psi)
      522 to 622 kPa
      (5.3 to 6.3 kgf/cm2, 76 to 90 psi)
      Stall test
      1,367 to 1,477 kPa
      (14.0 to 15.1 kgf/cm2, 198 to 214 psi)
      1,290 to 1,518 kPa
      (13.1 to 15.5 kgf/cm2, 187 to 220 psi)

      Evaluation: 
      Problem
      Possible cause
      Measured values are higher than specified in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured values are lower than specified in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leakage
      2. No. 1 clutch (C1) defective
      Pressure is low in R position only
      1. R position circuit fluid leakage
      2. No. 3 clutch (C3) defective
      3. No. 4 brake (B4) defective

← MECHANICAL SYSTEM TESTS (from Nov 2010)HYDRAULIC TEST (Aug 2009 – Oct 2010) →