HYDRAULIC TEST
Troubleshooting · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
| PERFORM HYDRAULIC TEST |
![]() ![]() |
Measure the line pressure.
- NOTICE:
- Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature of 50° to 80°C (122° to 176°F).
- The line pressure test should always be carried out in pairs. One technician should observe the condition of the wheels or wheel stoppers outside the vehicle while the other is doing the test.
- Be careful to prevent the SST hose from interfering with the exhaust pipe.
- This check must be conducted after checking and adjusting the engine.
- Perform with the A/C off.
- Do not conduct stall tests for longer than 5 seconds continuously.
- Perform the test at the normal operating ATF (Automatic Transmission Fluid) temperature of 50° to 80°C (122° to 176°F).
Warm up the ATF.
Lift the vehicle up.
Remove the test plug on the transmission case center right side and connect SST.
- SST
- 09992-00095
(09992-00231, 09992-00271)
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressing firmly on the brake pedal and shift into the D position.
Measure the line pressure while the engine is idling.
Depress the accelerator pedal all the way down. Quickly read the highest line pressure when the engine speed reaches the stall speed.
In the same manner, do the test in the R position.
- Specified line pressure:
Condition
D Position
R Position
Stall test
1200 to 1450 kPa
(12.2 to 14.8 kgf/cm2, 174 to 210 psi)
1150 to 1400 kPa
(11.7 to 14.3 kgf/cm2, 167 to 203 psi)
Evaluation: Problem
Possible cause
Measured values are higher than specified in all positions
- Shift solenoid valve SLT defective
- Regulator valve defective
Measured values are lower than specified in all positions
- Shift solenoid valve SLT defective
- Regulator valve defective
- Oil pump defective
Pressure is low in D position only
- D position circuit fluid leakage
- No. 1 clutch (C1) defective
Pressure is low in R position only
- R position circuit fluid leakage
- No. 3 clutch (C3) defective
- No. 4 brake (B4) defective

