2011-2016 FJ Cruiser · Service Manual TRANSMISSION

P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance

Diagnostic trouble codes · Vehicles built from Aug 2009

Versions by build date: Dec 2007 – Jul 2009 from Aug 2009

DESCRIPTION

The ECM detects the signal from the No. 1 transfer indicator switch (Transfer L4 position switch).
This DTC indicates that the No. 1 transfer indicator switch remains ON.
DTC No.
DTC Detection Condition
Trouble Area
P2772
No. 1 transfer indicator switch remains ON while vehicle running under following conditions for 1.8 seconds or more (1-trip detection logic).
  1. (a) Output shaft speed: between 1000 rpm and 3000 rpm
  2. (b) Transfer high and low shift lever position: H
  1. Short in No. 1 transfer indicator switch (Transfer L4 position switch) circuit
  2. No. 1 transfer indicator switch
  3. ECM

MONITOR DESCRIPTION

The ECM monitors the No. 1 transfer indicator switch to determine whether the transfer-case L4 gear is engaged. If the transfer-case L4 gears remain engaged under the following conditions, the ECM determines that there is a malfunction of the No. 1 transfer indicator switch:
  1. No. 1 transfer indicator switch indicates that the L4 transfer-case gears are engaged.
  2. Transfer high and low shift lever is in the "H" position.
  3. Transfer-case output shaft rpm is between 1000 and 3000 rpm.
  4. The specified time period has elapsed.
If all of the above conditions are met, the ECM determines that there is a malfunction of the No. 1 transfer indicator switch, illuminates the MIL and stores the DTC.

WIRING DIAGRAM

C189658E03

INSPECTION PROCEDURE


1. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (TRANSFER L4 POSITION SWITCH)
G034535E03
  1. Remove the No. 1 transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch ball is pushed
    Below 1 Ω
    Switch ball is not pushed
    10 kΩ or higher

    Text in Illustration 
    *1
    Component without harness connected:
    (No. 1 Transfer Indicator Switch)
    *a
    Push



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (ECM - NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND)

  1. C213112E02
    Install the No. 1 transfer indicator switch.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E82-16 (L4) - Body ground
    Transfer shift lever L4 position
    Below 1 Ω
    Transfer shift lever other than L4 position
    10 kΩ or higher

    Text in Illustration 
    *1
    Rear view of wire harness connector:
    (to ECM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (Dec 2007 – Jul 2009)REPLACEMENT (from Jul 2007) →