2011-2016 FJ Cruiser · Service Manual TRANSMISSION

P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance

Diagnostic trouble codes · Vehicles built Dec 2007 – Jul 2009

Versions by build date: Dec 2007 – Jul 2009 from Aug 2009

DESCRIPTION

The ECM detects the signal from the No. 1 transfer indicator switch (Transfer L4 position switch).
This DTC indicates that the No. 1 transfer indicator switch remains ON.
DTC No.
DTC Detection Condition
Trouble Area
P2772
No. 1 transfer indicator switch remains ON while vehicle running under following conditions for 1.8 seconds or more (1-trip detection logic).
  1. (a) Output shaft speed: between 1000 rpm and 3000 rpm
  2. (b) Transfer high and low shift lever position: H
  1. Short in No. 1 transfer indicator switch (Transfer L4 position switch) circuit
  2. No. 1 transfer indicator switch
  3. ECM

MONITOR DESCRIPTION

The ECM monitors the No. 1 transfer indicator switch to determine whether the transfer-case L4 gear is engaged. If the transfer-case L4 gears remain engaged under the following conditions, the ECM determines that there is a malfunction of the No. 1 transfer indicator switch:
  1. No. 1 transfer indicator switch indicates that the L4 transfer-case gears are engaged.
  2. Transfer high and low shift lever is in the "H" position.
  3. Transfer-case output shaft rpm is between 1000 and 3000 rpm.
  4. The specified time period has elapsed.
If all of the above conditions are met, the ECM determines that there is a malfunction of the No. 1 transfer indicator switch, illuminates the MIL and stores the DTC.

WIRING DIAGRAM

C179317E02

INSPECTION PROCEDURE


1. INSPECT NO. 1 TRANSFER INDICATOR SWITCH (TRANSFER L4 POSITION SWITCH)

  1. G034535E01
    Remove the No. 1 transfer indicator switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch ball is push
    Below 1 Ω
    Switch ball is not push
    10 kΩ or higher



NG
REPLACE NO. 1 TRANSFER INDICATOR SWITCH
OK


2. CHECK HARNESS AND CONNECTOR (ECM - NO. 1 TRANSFER INDICATOR SWITCH - BODY GROUND)

  1. C179329E01
    Install the No. 1 transfer indicator switch.

  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    B3-13 (L4) - Body ground
    Transfer shift lever L4 position
    Below 1 Ω
    Transfer shift lever other than L4 position
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)


← P2759 Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU) (from Aug 2009)P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (from Aug 2009) →