C1257 Power Supply Drive Circuit
Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Nov 2010 – Jul 2012 from Aug 2012
DESCRIPTION
The motor relay (semiconductor relay) is built into the hydraulic brake booster and drives the pump motor based on a signal from the skid control ECU.| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1257 |
Open in pump motor input circuit |
Master cylinder solenoid (Skid control ECU) |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CHECK HYDRAULIC BRAKE BOOSTER PUMP MOTOR OPERATION |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Check the hydraulic brake booster pump motor operation.
- OK:
- Hydraulic brake booster pump operates.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Turn the ignition switch off.
Reconnect the skid control ECU connector.
Turn the ignition switch to ON.
Clear the DTC (Click here).
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
