HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
- HINT:
- Use the following procedure to troubleshoot the engine immobiliser system.
- *: Use a intelligent tester .
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS CHECK |
- HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- The following 5 items are important points in the problem analysis:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
| What |
Vehicle model, system name |
| When |
Date, time, occurrence frequency |
| Where |
Road conditions |
| Under what conditions? |
Driving conditions, weather conditions |
| How did it happen? |
Problem symptoms |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
- Standard voltage:
- 11 to 14 V
| |||||
| 4.CRANK ENGINE FOR MORE THAN 10 SECONDS |
| |||||
| 5.CHECK FOR DTCS* |
Check for DTCs and note any codes that are output (Click here).
Delete the DTCs (Click here).
Recheck for DTCs. Try to duplicate the DTCs (SFI system and engine immobiliser system) by simulating the symptoms indicated by the DTCs.
- Result:
Result
Proceed to
DTC does not recur
A
DTC (SFI system) recurs
B
DTC (engine immobiliser system) recurs
C
|
|||||
|
|||||
| |||||
| 6.READ VALUE USING INTELLIGENT TESTER* |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on tester, read the "Data List".
- OK:
- ON (Key is in ignition key cylinder) appears on the screen.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Key SW |
Unlock warning switch signal/ON or OFF |
ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder |
- |
|
|||||
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
- Result:
Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 8.OVERALL ANALYSIS AND TROUBLESHOOTING* |
DATA LIST / ACTIVE TEST (Click here)
TERMINALS OF ECU (Click here)
| |||||
| 9.ADJUST, REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
| |||||