B2796 No Communication in Immobiliser System
Diagnostic trouble codes · Vehicles built from Nov 2010
Also covers:
- B2798 Communication Malfunction No. 2
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
DESCRIPTION
These DTCs are output if a key that does not have a transponder chip is inserted into the ignition key cylinder or if communication between the key and transponder key ECU is impossible.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B2796 |
The key code cannot be transmitted |
|
| B2798 |
Key code identification cannot be completed within the specified time (0.15 to 0.5 sec.) |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
- If the key is replaced, register the key.
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
| 1. READ VALUE USING INTELLIGENT TESTER |
Connect a intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester ON.
Enter the following menus: Body Electrical / Immobiliser / Data List.
According to the display on tester, read the "Data List".
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Immobiliser |
Immobiliser system status/SET or UNSET |
UNSET: Ignition switch ON SET: Without key |
- |
- OK:
- UNSET (Ignition switch ON) appears on the screen.
|
|
||||
| OK | ||
| ||
| 2. CHECK KEYS |
Insert the vehicle's other key into the ignition key cylinder.
Check that the engine starts with this key.
- OK:
- The engine starts.
|
|
||||
| OK | ||
| ||
| 3. REPLACE TRANSPONDER KEY AMPLIFIER |
Replace the transponder key amplifier (Click here).
| NEXT | |
| 4. CHECK ENGINE START |
Check that the engine starts.
- OK:
- The engine starts.
|
|
||||
| OK | ||
| ||
