INSTALLATION
Removal / installation · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
| 1. INSTALL TRANSFER ASSEMBLY |
Install the transfer onto the transmission.
Install the 2 clamps and 8 bolts.
- Torque:
- 24 N*m{ 244 kgf*cm , 17 ft.*lbf }
| 2. INSTALL MANUAL TRANSMISSION ASSEMBLY |
Install the manual transmission (Click here).
| 3. INSTALL LOWER TRANSFER CASE PROTECTOR |
![]() ![]() |
Install the protector with the 5 bolts.
- Torque:
- 18 N*m{ 183 kgf*cm , 13 ft.*lbf }
Install the brake hose clamp.
| 4. ADD TRANSFER OIL |
Remove the case plug (for filler) and gasket.
Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.20 in.) from the bottom lip of the case plug (for filler) hole.
- NOTICE:
- When adding oil, pour it slowly.
- Add oil a little at a time, waiting several minutes between each addition of oil.
- When adding oil, pour it slowly.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket and the case plug (for filler).
- Torque:
- 37 N*m{ 377 kgf*cm , 27 ft.*lbf }
| 5. CHECK FOR TRANSFER OIL LEAKAGE |
| 6. CHECK FOR EXHAUST GAS LEAK |


