2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

No Answer-Back

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

In this case, wireless control functions are normal but the hazard warning light or wireless door lock buzzer answer-back function does not operate.

WIRING DIAGRAM

B133372E03

INSPECTION PROCEDURE


1. CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS
  1. Check the wireless door lock functions by operating the transmitter switches.

    Result 
    Result
    Proceed to
    Wireless door lock functions are normal
    A
    Wireless door lock functions are abnormal
    B



B
HOW TO PROCEED WITH TROUBLESHOOTING (Click here)
A


2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (WIRELESS DOOR LOCK BUZZER, FLASHER RELAY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. According to the display on the tester, perform the Active Test.


Main Body:
Tester Display
Test Part
Control Range
Diagnostic Note
Hazard
Flasher relay
ON or OFF
-
Wireless Buzzer*1
Sounds wireless buzzer
ON or OFF
-

Result 
Result
Proceed to
Hazard warning light answer-back function does not operate
A
Wireless door lock buzzer answer-back function does not operate*1
B
Hazard warning light and wireless door lock buzzer*1 answer-back function operate normally
C
  1. *1: w/ Wireless door lock buzzer


B
Go to step 4

C
REPLACE MAIN BODY ECU
A


3. CHECK HAZARD WARNING LIGHTS
  1. Check that the hazard warning lights flash when the hazard warning signal switch is pressed.

    OK:
    Hazard warning lights flash when hazard warning signal switch is pressed.



NG
GO TO LIGHTING SYSTEM (Click here)
OK

REPLACE MAIN BODY ECU

4. CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MAIN BODY ECU)

  1. B062227E04
    Disconnect the A12 wireless door lock buzzer connector.

  1. Disconnect the 1B main body ECU connector.

  1. Measure the resistance.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1B-10 (BZR) - A12-1
    Always
    Below 1 Ω
    1B-6 (BZR2) - A12-2
    Always
    Below 1 Ω
    1B-10 (BZR) orA12-1 - Body ground
    Always
    10 kΩ or higher
    1B-6 (BZR2) or A12-2 - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the buzzer connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. REPLACE WIRELESS DOOR LOCK BUZZER
  1. Temporarily replace the wireless door lock buzzer with a new or normally functioning one (Click here).

  1. Check that the buzzer sounds when using the transmitter LOCK and UNLOCK switches.

    OK:
    The buzzer sounds.

    NOTICE:
    When battery voltage is directly applied to the buzzer, the buzzer does not sound.

    HINT:
    The buzzer circuit is built into the main body ECU, not into the buzzer itself.



NG
REPLACE MAIN BODY ECU
OK

END (WIRELESS DOOR LOCK BUZZER IS DEFECTIVE)


← No Answer-Back (Jul 2007 – Oct 2010)PARTS LOCATION (Jul 2007 – Oct 2010) →