2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. INSTALL CLUTCH SWITCH ASSEMBLY

  1. E129558E01
    Fully loosen the lock nut of the clutch switch assembly.

  1. Adjust the clutch switch until the threaded portion comes into contact with the cushion. Tighten the lock nut and ensure that the threaded portion is in contact with the cushion.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

  1. Connect the connector.


2. INSTALL MAIN BODY ECU (DRIVER SIDE J/B)

E129556
  1. Install the main body ECU with the 2 nuts.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }


3. INSTALL INSTRUMENT PANEL SIDE BRACKET

E129555
  1. Install the instrument panel side bracket with the bolt.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 in.*lbf }


4. INSTALL LOWER INSTRUMENT PANEL LH

  1. B133864
    Install the lower instrument panel with the 4 <F> bolts.


5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

  1. B133860
    Engage the 5 clips and claw and install the lower instrument panel finish panel.

  1. Install the 2 <F> bolts.


6. INSTALL INSTRUMENT PANEL FINISH PLATE

E149563E01
  1. Install the instrument panel finish plate.


7. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

  1. B133859
    Engage the 3 claws and install the hood lock control lever.


8. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

  1. B133853
    Engage the 4 clips and 2 claws and install the instrument panel register.


9. INSTALL COWL SIDE TRIM BOARD LH

E129563
  1. Engage the 2 claws and install the cowl side trim board.

  1. Install the clip.


10. INSTALL FOOTREST CLIP

B130588

HINT:
Use the same procedure for both sides.

  1. Engage the 2 claws and install the footrest clip.


11. INSTALL FRONT FLOOR FOOTREST

  1. B130589
    Engage the 2 studs and install the front floor footrest.


12. INSTALL FRONT DOOR SCUFF PLATE LH

E129562
  1. Engage the 14 claws and install the door scuff plate.


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSPECTION (from Jul 2007)INSTALLATION (from Nov 2010) →