2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

REMOVAL

Removal / installation · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR SCUFF PLATE LH

  1. E129562
    Disengage the 14 claws and remove the front door scuff plate.


3. REMOVE FRONT FLOOR FOOTREST

  1. B130586
    Disengage the 4 claws and remove the front floor footrest.


4. REMOVE FOOTREST CLIP

  1. B130587
    Remove the 2 footrest clips.


5. REMOVE COWL SIDE TRIM BOARD LH

  1. E129563
    Remove the clip.

  1. Disengage the 2 claws and remove the cowl side trim board.


6. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

  1. B133853
    Disengage the 4 clips and 2 claws and remove the instrument panel register.

    NOTICE:
    1. To avoid breakage of the register, remove the instrument panel register with the shut damper of the register open.
    2. Pull the instrument panel register up diagonally to remove it.


7. SEPARATE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

  1. B133859
    Disengage the 3 claws and separate the hood lock control lever.


8. REMOVE INSTRUMENT PANEL FINISH PLATE

  1. E149562E03
    Using a screwdriver with its tip wrapped in protective tape, remove the instrument panel finish plate.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Instrument Panel Finish Plate


9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH

  1. B133860
    Remove the 2 <E> bolts.

  1. Disengage the 5 clips and claw and remove the lower instrument panel finish panel.


10. REMOVE LOWER INSTRUMENT PANEL LH

  1. B133864
    Remove the 4 <E> bolts and the lower instrument panel.


11. REMOVE INSTRUMENT PANEL SIDE BRACKET

  1. E129555
    Remove the bolt and remove the instrument panel side bracket.


12. SEPARATE MAIN BODY ECU (DRIVER SIDE J/B)

  1. E129556
    Remove the 2 nuts and separate the main body ECU.


13. REMOVE CLUTCH SWITCH ASSEMBLY

  1. E129557
    Disconnect the connector.

  1. Loosen the nut and remove the clutch switch assembly.

← REMOVAL (Jul 2007 – Oct 2010)INSPECTION (from Jul 2007) →