REMOVAL
Removal / installation · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012
| 1.
REMOVE REAR BUMPER COVER
|
 |
- Apply protective tape as shown in the illustration.
- Remove the clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 7 bolts and the 2 screws.
- Disengage the wire harness clamp, and disconnect the connector.
- Disengage the 6 claws and the 2 clips and remove the rear bumper cover.
| 2.
REMOVE NO. 8 FLOOR WIRE
|
 |


Disconnect the connectors.
Disengage the clamps and remove the floor wire.
| 3.
REMOVE REAR BUMPER SIDE RETAINER RH
|
 |
- Remove the 3 screws and rear bumper extension retainer.
| 4.
REMOVE REAR BUMPER SIDE RETAINER LH |
 |
- HINT:
- Use the same procedure as for the RH side.
| 5.
REMOVE REAR FOG LIGHT ASSEMBLY LH
|
 |
Disconnect the 2 connectors and wire harness clamp.
Remove the 2 screws and rear fog light.
| 6.
REMOVE REAR FOG LIGHT ASSEMBLY RH
|
 |
Disconnect the 2 connectors and wire harness clamp.
Remove the 2 screws and rear fog light.
| 7.
REMOVE REAR BUMPER EXTENSION MOULDING LH
|
 |
- Disengage the 4 claws and remove the rear bumper extension moulding.
| 8.
REMOVE REAR BUMPER EXTENSION MOULDING RH
|
 |
- HINT:
- Use the same procedure as for the LH side.
| 9.
REMOVE ULTRASONIC SENSOR |
 |
Disconnect the sensor connector.
- While pushing down on the lever with a finger to release the claw, disengage the claw on the other side to remove the ultrasonic sensor.
- HINT:
- The types of the claws on the top and bottom of the sensor are different. Observe the claws carefully before attempting to remove the sensor.
| 10.
REMOVE ULTRASONIC SENSOR RETAINER |
 |
- Disengage the 2 claws and remove the ultrasonic sensor retainer from the rear bumper.