2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

The stereo jack adapter sends an external device sound signal to the radio receiver through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM

E148140E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - NOISE FILTER)

  1. E130791E01
    Disconnect the E71 noise filter and E43 radio receiver connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    E71-5 (AUXO) - E43-19 (AUXI)
    Below 1 Ω
    E71-8 (ALO) - E43-17 (ALI)
    Below 1 Ω
    E71-7 (ARO) - E43-15 (ARI)
    Below 1 Ω
    E71-6 (ASGO) - E43-16 (ASGN)
    Below 1 Ω
    E71-5 (AUXO) or E43-19 (AUXI) - Body ground
    10 kΩ or higher
    E71-8 (ALO) or E43-17 (ALI) - Body ground
    10 kΩ or higher
    E71-7 (ARO) or E43-15 (ARI) - Body ground
    10 kΩ or higher
    E71-6 (ASGO) or E43-16 (ASGN) - Body ground
    10 kΩ or higher

  1. Reconnect the noise filter connector.

  1. Reconnect the radio receiver connector.



MG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (NOISE FILTER - STEREO JACK ADAPTER)

  1. E130792E01
    Disconnect the E26 stereo jack adapter and E71 noise filter connectors.

  1. Measure the resistance.

    Standard resistance:
    Tester connection
    Specified condition
    E26-1 (ALO) - E71-1 (ALI)
    Below 1 Ω
    E26-2 (ARO) - E71-2 (ARI)
    Below 1 Ω
    E26-3 (ASGN) - E71-3 (ASG1)
    Below 1 Ω
    E26-1 (ALO) or E71-1 (ALI) - Body ground
    10 kΩ or higher
    E26-2 (ARO) or E71-2 (ARI) - Body ground
    10 kΩ or higher
    E26-3 (ASGN) or E71-3 (ASG1) - Body ground
    10 kΩ or higher

  1. Reconnect the stereo jack adapter connector.

  1. Reconnect the noise filter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Multi-media Interface ECU (from Nov 2010)Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (from Nov 2010) →