2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jul 2007


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

REMOVE EFI RELAY

A126393E03
  1. Remove the relay block cover upper.

  1. Remove the EFI relay.


INSPECT EFI RELAY

A126370
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      Below 1 Ω
      (Battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the EFI relay.


INSTALL EFI RELAY
  1. Install the EFI relay.

  1. Install the relay block cover upper.


CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSTALLATION (from Aug 2009)ON-VEHICLE INSPECTION (from Jul 2007) →