ON-VEHICLE INSPECTION
Inspection · Vehicles built from Jul 2007
| DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| REMOVE CIRCUIT OPENING RELAY |
![]() ![]() |
Remove the relay block cover upper.
Remove the circuit opening relay.
| INSPECT CIRCUIT OPENING RELAY |
![]() ![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Specified Condition
3 - 5
10 kΩ or higher
Below 1 Ω
(Battery voltage applied to terminals 1 and 2)
| INSTALL CIRCUIT OPENING RELAY |
Install the circuit opening relay.
Install the relay block cover upper.
| CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- Torque:
- 3.9 N*m{ 40 kgf*cm , 35 in.*lbf }



