ON-VEHICLE INSPECTION
Inspection · Vehicles built from Aug 2009
| REMOVE AIR FUEL RATIO SENSOR HEATER RELAY |
Remove the upper relay block cover.

Remove the relay.
Text in Illustration *1
Air Fuel Ratio Sensor Heater Relay
| INSPECT AIR FUEL RATIO SENSOR HEATER RELAY |
![]() ![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
3 - 4
Battery voltage not applied
Below 1 Ω
Battery voltage applied to terminals 1 and 2
10 kΩ or higher
3 - 5
Battery voltage not applied
10 kΩ or higher
Battery voltage applied to terminals 1 and 2
Below 1 Ω
| INSTALL AIR FUEL RATIO SENSOR HEATER RELAY |
Install the relay.
Install the upper relay block cover.

