2011-2016 FJ Cruiser · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Jul 2007 – Jul 2009


DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

REMOVE FUEL PUMP RELAY

A126393E01
  1. Remove the relay block cover upper.

  1. Remove the fuel pump relay.


INSPECT FUEL PUMP RELAY

A126371
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 4
      Below 1 Ω
      10 kΩ or higher
      (Battery voltage applied to terminals 1 and 2)
      3 - 5
      10 kΩ or higher
      Below 1 Ω
      (Battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the fuel pump relay.


INSTALL FUEL PUMP RELAY
  1. Install the fuel pump relay.

  1. Install the relay block cover upper.


CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← ON-VEHICLE INSPECTION (from Jul 2007)ON-VEHICLE INSPECTION (from Aug 2009) →