2011-2016 FJ Cruiser · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built Nov 2010 – Jul 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. INSTALL ROOF WIRE

  1. Apply new double-sided tape to the roof headlining along the markings of the roof headlining.

    B209865E03

    Text in Illustration 
    *1
    Double-sided Tape
    -
    -
    *a
    Marking
    -
    -

    NOTICE:
    1. Apply the tape securely in place.
    2. Do not touch the adhesive surface when applying the tape to prevent adhesion failure.

  1. Install the roof wire as shown in the illustration.

    B209866E03

    Text in Illustration 
    *1
    Marking Tape
    *2
    Fixed Tape

    NOTICE:
    1. Do not twist the flat wire harness when installing it.
    2. Securely fix the wire harness by pressing it.
    3. Securely fix the wire harness to secure a gap between the wire harness and the roof panel in part A.
    4. Securely fix the wire harness to avoid looseness in the wire harness between portion B and the marking tape.


2. INSTALL ROOF SILENCER PAD
  1. Apply double-sided tape to the roof silencer pad.

  1. Align the 2 roof silencer pads with the markings of the roof headlining and install them onto the roof headlining.

    B130650E03

    Text in Illustration 
    *a
    Marking
    -
    -


3. INSTALL ROOF SPEAKER ASSEMBLY (except 10 Speakers)

B138635E05

HINT:
Use the same procedure for both sides.

Text in Illustration 
*a
for RH Side
*b
for LH Side
  1. Install the roof speaker by turning it in the direction of the arrow shown in the illustration.

  1. B135049E06
    Tighten the screw.
    Text in Illustration 
    *a
    for RH Side
    *b
    for LH Side

  1. Connect the speaker connector.

  1. B151255E05
    Cover the engaged portion of the connector and the lead line with a new hole cover, and attach them to the roof headlining securely.
    Text in Illustration 
    *a
    for RH Side
    *b
    for LH Side

    NOTICE:
    Securely attach the hole cover to the roof headlining to avoid looseness in the connector and the lead line.

← REASSEMBLY (Jul 2007 – Oct 2010)REASSEMBLY (from Aug 2012) →