2011-2016 FJ Cruiser · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

NOTICE:
  1. Be sure to read precaution thoroughly before servicing (Click here).
  2. Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
  3. If the front seat side airbag assembly was deployed, replace the front seat side airbag assembly, front seat adjuster sub-assembly, front seatback cover and front seatback pad with the necessary parts in accordance with the extent of the collision damage (Click here).

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE FRONT SEAT TRACK COVER

B130664E01

HINT:
Use the same procedure for both sides.

  1. Insert a flat- head screwdriver (diameter: approximately above 5 mm (0.197 in.)) between the front seat track cover inside claw lower part and floor mat.

  1. Place an object with a height of approximately 5 to 8 mm (0.197 to 0.315 in.) below the screwdriver. Use the object as the screwdriver fulcrum and push down on the screwdriver to remove the front seat track cover inside claw, as shown in the illustration.

    Specification: 
    Area
    Measurement
    a
    1.6 mm (0.063 in.)
    b
    5.0 mm (0.197 in.)
    c
    5.0 to 8.0 mm (0.197 to 0.315 in.)

  1. B138596E01
    Lift up on the area where the claw was removed. Then push in the direction of the claw on the opposite side to remove the outside claw.

  1. B138597E01
    After the 2 claws have been removed, carefully pull the front seat track cover rearward and remove the front seat track cover.


3. REMOVE FRONT SEAT ASSEMBLY

  1. B135117E01
    for Driver Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the 2 buckle switch connectors.

    3. w/ Front Seat Side Airbag:

      1. Slide the slider and disconnect the airbag connector.

  1. B177955E01
    for Front Passenger Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the connector.

    3. w/ Front Seat Side Airbag:

      1. Slide the slider and disconnect the airbag connector.

  1. B130665
    Move the front seat to the most forward position.

  1. Remove the 2 bolts from the rear side.

  1. Move the front seat to the most rearward position.

  1. Remove the 2 bolts from the front side.

  1. Remove the front seat.


4. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

  1. B130680
    Disconnect the 2 front seatback cover bands.


5. REMOVE VERTICAL SEAT ADJUSTER HANDLE COVER (for Driver Side)

  1. B130670E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the vertical seat adjuster handle cover.


6. REMOVE VERTICAL SEAT ADJUSTER HANDLE (for Driver Side)

  1. B130672
    Remove the 2 screws and the vertical seat adjuster handle.


7. REMOVE RECLINING ADJUSTER RELEASE HANDLE

  1. B130673E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the reclining adjuster release handle.


8. REMOVE FRONT SEAT CUSHION OUTER SHIELD

  1. B130675E01
    Remove the screw.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and the clip and remove the front seat cushion outer shield.


9. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. B130776
    for Driver Side:

    1. Disconnect the seat position sensor connector.

    2. Using a clip remover, remove the 2 connectors and the clamp.

    3. Remove the clamp.

  1. B177952
    for Front Passenger Side:

    1. Disconnect the buckle switch connector.

    2. Disconnect the occupant classification sensor connector.

    3. Using a clip remover, remove the connector and the 2 clamps.

  1. B130777
    Remove the wire harness from the claw of the front seat cushion inner shield.

  1. Remove the nut and the front seat inner belt.


10. REMOVE FRONT SEAT CUSHION INNER SHIELD

  1. B130677E01
    Remove the screw.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and the clip and remove the front seat cushion inner shield.


11. REMOVE FRONT SEAT HEADREST ASSEMBLY

  1. B130684E01
    Push in the lock button of the front seat headrest support and remove the front seat headrest.


12. REMOVE FRONT SEAT ARMREST CAP (w/ Armrest)

  1. B130685E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the front seat armrest cap.


13. REMOVE FRONT SEAT ARMREST COVER (w/ Cover)

  1. B130687E01
    Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the front seat armrest cover.


14. REMOVE FRONT SEAT ARMREST ASSEMBLY (w/ Armrest)

  1. B130689
    Remove the bolt, the bush and the front seat armrest.


15. REMOVE FRONT SEAT HEADREST SUPPORT

  1. w/ Front Seat Side Airbag:

    1. B332547
      Disengage the 3 clamps to separate the front seat side airbag wire harness.

  1. B130690
    Remove the 3 hog rings.

  1. w/ Front Seat Side Airbag:

    1. B332546
      Pull out the front seat side airbag wire harness from the front seatback cover.

  1. B130692
    Remove the 2 hog rings.

  1. Unfasten the 2 zippers.

  1. B130694
    Disengage the 2 claws and remove the front seat headrest support.

    HINT:
    Use the same procedure for both sides.


16. REMOVE FRONT SEATBACK ASSEMBLY

  1. B130696
    Using a clip remover, remove the 2 clips.

  1. Remove the 4 hog rings.

  1. w/ Front Seat Side Airbag:

    1. Remove the nut.

  1. B130698
    Remove the front seatback.


17. REMOVE FRONT SEAT SIDE AIRBAG ASSEMBLY

  1. B328561
    Disengage the 2 clamps.

  1. Remove the 2 nuts and front seat side airbag assembly.

    NOTICE:
    1. The nuts must not be reused.
    2. Make sure that the front seat adjuster sub-assembly is not deformed. If it is, replace it with a new one.

← ON-VEHICLE INSPECTION (from Nov 2010)REMOVAL (from Nov 2010) →