2011-2016 FJ Cruiser · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. REMOVE ACCESS PANEL REAR WEATHERSTRIP

B135524
  1. Remove the access panel rear weatherstrip.


3. REMOVE LAP BELT OUTER ANCHOR COVER

B135525
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.


4. REMOVE ACCESS DOOR INSIDE HANDLE SUB-ASSEMBLY

B135527
  1. Insert a clip remover between the handle and door trim.

  1. Turn the handle with the clip remover inserted, as shown in the illustration.

  1. Remove the rear door inside handle and snap ring.


5. REMOVE CUP HOLDER

B135528
  1. Remove the screw and the No. 1 cup holder.


6. REMOVE ACCESS DOOR TRIM BOARD SUB-ASSEMBLY

B135526
  1. Remove the bolt and separate the front seat belt outer (floor side).

  1. B135558
    Disengage the 9 clips and remove the rear door trim panel.


7. REMOVE CENTER PILLAR UPPER GARNISH

B135559
  1. Remove the clip.

  1. Remove the 2 screws.

  1. B135560
    Disengage the 2 clips and remove the center pillar upper garnish.


8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

  1. B135087
    Remove the nut and the through anchor.

  1. B135089E01
    for RH Side:

    1. Using a screwdriver, release the locking button of the pretensioner connector.

    2. Using a screwdriver, disconnect the pretensioner connector.

    3. B135088
      Remove the 2 bolts, the 2 hooks and the retractor.

  1. B135092
    for LH Side:

    1. Disconnect the tension reducer connector.

    2. Remove the 2 bolts, the 2 hooks and the retractor.

    3. B135093E01
      Using a screwdriver, release the locking button of the pretensioner connector.

    4. Using a screwdriver, disconnect the pretensioner connector.


9. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

  1. B135095
    Remove the 2 bolts, the hook and the shoulder belt anchor adjuster.

← COMPONENTS (from Nov 2010)REMOVAL (Nov 2010 – Jul 2012) →