Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2.
REMOVE ACCESS PANEL REAR WEATHERSTRIP
Remove the access panel rear weatherstrip.
3.
REMOVE LAP BELT OUTER ANCHOR COVER
Disengage the 3 claws and remove the lap belt outer anchor cover.
4.
REMOVE ACCESS DOOR INSIDE HANDLE SUB-ASSEMBLY
Insert a clip remover between the handle and door trim.
Turn the handle with the clip remover inserted, as shown in the illustration.
Remove the rear door inside handle and snap ring.
5.
REMOVE CUP HOLDER
Remove the screw and the No. 1 cup holder.
6.
REMOVE ACCESS DOOR TRIM BOARD SUB-ASSEMBLY
Remove the bolt and separate the front seat belt outer (floor side).
Disengage the 9 clips and remove the rear door trim panel.
7.
REMOVE CENTER PILLAR UPPER GARNISH
Remove the clip.
Remove the 2 screws.
Disengage the 2 clips and remove the center pillar upper garnish.
8.
REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and the through anchor.
Using a screwdriver, release the locking button of the pretensioner connector.
Using a screwdriver, disconnect the pretensioner connector.
Text in Illustration
*1
Locking Button
Remove the 2 bolts, the 2 hooks and the retractor.
9.
REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts, the hook and the shoulder belt anchor adjuster.