2011-2016 FJ Cruiser · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (w/ Front Seat Side Airbag) (Click here).

HINT:
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working (w/ Front Seat Side Airbag).


2. REMOVE FRONT SEAT TRACK COVER

B130664E01

HINT:
Use the same procedure for both sides.

  1. Insert a flat- head screwdriver (diameter: approximately above 5 mm (0.197 in.)) between the front seat track cover inside claw lower part and floor mat.

  1. Place an object with a height of approximately 5 to 8 mm (0.197 to 0.315 in.) below the screwdriver. Use the object as the screwdriver fulcrum and push down on the screwdriver to remove the front seat track cover inside claw, as shown in the illustration.

    Specification: 
    Area
    Measurement
    a
    1.6 mm (0.063 in.)
    b
    5.0 mm (0.197 in.)
    c
    5.0 to 8.0 mm (0.197 to 0.315 in.)

  1. B138596E01
    Lift up on the area where the claw was removed. Then push in the direction of the claw on the opposite side to remove the outside claw.

  1. B138597E01
    After the 2 claws have been removed, carefully pull the front seat track cover rearward and remove the front seat track cover.


3. REMOVE FRONT SEAT ASSEMBLY

  1. B135117E01
    for Driver Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the 2 buckle switch connectors.

    3. w/ Front Seat Side Airbag:

      1. Slide the slider and disconnect the airbag connector.

  1. B177955E01
    for Front Passenger Side:

    1. Using a clip remover, remove the clamp.

    2. Disconnect the connector.

    3. w/ Front Seat Side Airbag:

      1. Slide the slider and disconnect the airbag connector.

  1. B130665
    Move the front seat to the most forward position.

  1. Remove the 2 bolts from the rear side.

  1. Move the front seat to the most rearward position.

  1. Remove the 2 bolts from the front side.

  1. Remove the front seat.


4. REMOVE FRONT SEAT INNER BELT ASSEMBLY

  1. B130776
    for Driver Side:

    1. Disconnect the seat position sensor connector.

    2. Using a clip remover, remove the 2 connectors and the clamp.

    3. Remove the clamp.

  1. B177952
    for Front Passenger Side:

    1. Disconnect the buckle switch connector.

    2. Disconnect the occupant classification sensor connector.

    3. Using a clip remover, remove the connector and the 2 clamps.

  1. B130777
    Remove the wire harness from the claw of the front seat cushion inner shield.

  1. Remove the nut and the front seat inner belt.

← REMOVAL (Nov 2010 – Jul 2012)INSPECTION (Jul 2007 – Oct 2010) →