INSTALLATION
Removal / installation · Vehicles built from Jul 2007
- HINT:
- The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1.
INSTALL FRONT NO. 1 SPEAKER ASSEMBLY |
 |
- Install the front No. 1 speaker with the 4 screws.
-
Torque:
- 2.5 N*m{
25 kgf*cm
, 22 in.*lbf
}
- Connect the speaker connector.
| 2.
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
|
 |
Connect the front door lock remote control cable and front door inside locking cable.
- Engage the 10 clips and install the front door trim board.
- Tighten the 2 screws.
- for LH side:
Close the 2 covers.
- for RH side:
Close the 2 covers.
| 3.
INSTALL FRONT DOOR ARMREST BASE UPPER PANEL
|
 |
Connect the connector.
Engage the 3 claws and clip and install the front armrest base upper panel.
| 4.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
 |
-
Torque:
- 3.9 N*m{
40 kgf*cm
, 35 in.*lbf
}