REMOVAL
Removal / installation · Vehicles built from Jul 2007
- HINT:
- The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL |
![]() ![]() |
Disengage the 3 claws and clip and remove the front armrest base upper panel.
Disconnect the connector.
| 3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() ![]() |
for LH side:
Using a screwdriver with its tip wrapped in protective tape, open the 2 covers.
for RH side:

Using a screwdriver with its tip wrapped in protective tape, open the 2 covers.
Remove the 2 screws.

Disengage the 10 clips.

Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board.

| 4. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY |
Disconnect the speaker connector.

Remove the 4 screws and the front No. 1 speaker.



