2011-2016 FJ Cruiser · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built Nov 2010 – Oct 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012


1. INSTALL REAR BUMPER BAR BRACKET LH

  1. B271016
    Insert the hook into the body hole and install the rear bumper bar bracket with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


2. INSTALL REAR BUMPER BAR BRACKET RH

HINT:
Use the same procedure as for the LH side.


3. INSTALL REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY LH

  1. B271868
    Align the locating pin with the hole and install the rear bumper side support with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


4. INSTALL REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


5. INSTALL REAR BUMPER SIDE STAY LH

  1. B271869
    Insert the hook into the body hole and install the rear bumper side stay with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


6. INSTALL REAR BUMPER SIDE STAY RH

HINT:
Use the same procedure as for the LH side.


7. INSTALL REAR BUMPER ENERGY ABSORBER
  1. Engage the 2 claws and install the rear bumper energy absorber.


8. INSTALL REAR BUMPER UPPER RETAINER LH
  1. Engage the 3 claws and install the rear bumper upper retainer.

  1. Tighten the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


9. INSTALL REAR BUMPER UPPER RETAINER RH

HINT:
Use the same procedure as for the LH side.


10. INSTALL REAR BUMPER END RETAINER LH
  1. Engage the 2 claws and install the rear bumper end retainer.

  1. Tighten the screw.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


11. INSTALL REAR BUMPER END RETAINER RH

HINT:
Use the same procedure as for the LH side.


12. INSTALL REAR BUMPER COVER
  1. Engage the 6 claws and the 2 clips and install the rear bumper cover.

  1. Connect the connector.

  1. Connect the clamp and install the floor wire.

    HINT:
    If the vehicle is equipped with back sonar, connect the connector and install the floor wire.

  1. Tighten the 7 bolts and the 2 screws.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf } for bolt
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } for screw

← INSTALLATION (Jul 2007 – Oct 2010)INSTALLATION (from Nov 2012) →