2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Nov 2012

Versions by build date: Jul 2007 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012


1. REMOVE REAR BUMPER COVER

  1. B190458E03
    Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. B198720
    Remove the clip.

  1. B332240
    Remove the 7 bolts and the 2 screws.

  1. B329571
    Disengage the clamp and disconnect the connector.

  1. B190460
    Disengage the 6 claws and the 2 clips and remove the rear bumper cover.


2. REMOVE REAR BUMPER END RETAINER LH

  1. B134750
    Remove the screw.

  1. Disengage the 2 claws and remove the rear bumper end retainer LH.


3. REMOVE REAR BUMPER END RETAINER RH

HINT:
Use the same procedure as for the LH side.


4. REMOVE REAR BUMPER UPPER RETAINER LH

  1. B134751
    Remove the 2 screws.

  1. Disengage the 3 claws and remove the rear bumper upper retainer LH.


5. REMOVE REAR BUMPER UPPER RETAINER RH

HINT:
Use the same procedure as for the LH side.


6. REMOVE REAR BUMPER ENERGY ABSORBER

  1. B190461
    Remove the rear bumper energy absorber.


7. REMOVE REAR BUMPER SIDE STAY LH

  1. B332239
    Remove the bolt, disengage the hook and remove the rear bumper side stay LH.


8. REMOVE REAR BUMPER SIDE STAY RH

HINT:
Use the same procedure as for the LH side.


9. REMOVE REAR BUMPER BAR BRACKET LH

  1. B329574
    Remove the 2 bolts and the rear bumper bar bracket LH.


10. REMOVE REAR BUMPER BAR BRACKET RH

  1. B332235
    Remove the 2 bolts and the rear bumper bar bracket RH.


11. REMOVE REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY LH (for Single Tank Type)

  1. B340071E01
    Disengage the clamp and separate the wire harness.
    Text in Illustration 
    *1
    Clamp
    *2
    Guide

  1. Remove the 2 bolts.

  1. Disengage the 2 guides and remove the rear bumper side support sub-assembly LH.


12. REMOVE REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY RH (for Single Tank Type)

  1. B340072
    Remove the 2 bolts.

  1. Disengage the 2 guides and remove the rear bumper side support sub-assembly RH.


13. REMOVE FUEL SUB TANK SUB-ASSEMBLY (for Double Tank Type)
(Click here)

14. REMOVE NO. 4 FUEL TANK BAND BRACKET (for Double Tank Type)

  1. for LH Side:

    1. B340052
      Disengage the 3 clamps and separate the wire harness.

    2. Remove the 4 bolts and the No. 4 fuel tank band bracket.

  1. for RH Side:

    1. B340051
      Remove the 4 bolts and the No. 4 fuel tank band bracket.

← REMOVAL (Aug 2012 – Oct 2012)DISASSEMBLY (Jul 2007 – Oct 2010) →