2011-2016 FJ Cruiser · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. INSTALL REAR BUMPER LOWER COVER

  1. B135151
    Install the 4 screw grommets.

  1. B135150
    Engage the 4 clips and install the rear bumper lower cover.

  1. Tighten the 4 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


2. INSTALL REFLEX REFLECTOR ASSEMBLY LH

  1. B135149
    Install the reflex reflector with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


3. INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


4. INSTALL REAR BUMPER PAD LH

  1. B135148
    Engage the 5 claws and install the rear bumper pad.

  1. Install the 5 retainers.


5. INSTALL REAR BUMPER PAD RH

HINT:
Use the same procedure as for the LH side.


6. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ Back Sonar)

  1. E185141E01
    Temporarily install the ultrasonic sensor retainer to the rear bumper.
    Text in Illustration 
    *1
    Protrusion
    *2
    Keyhole

    NOTICE:
    1. Do not damage the rear bumper with the protrusion when installing the retainer.
    2. Securely install the ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the rear bumper.

    HINT:
    1. When installing the retainer, align the keyhole and protrusion as shown in the illustration.
    2. Use the same procedure for the remaining parts.

  1. Engage the 2 claws to install the ultrasonic sensor retainer.

    HINT:
    Use the same procedure for the remaining parts.


7. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Back Sonar)

  1. E185142
    Engage the 2 claws to install the ultrasonic sensor.

    NOTICE:
    Push the ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.

    HINT:
    Use the same procedure for the remaining parts.


8. INSTALL NO. 8 FLOOR WIRE (w/ Back Sonar)
  1. Engage the 7 clamps and install the floor wire.

  1. Connect the 2 connectors.

← REASSEMBLY (Jul 2007 – Oct 2010)INSTALLATION (Jul 2007 – Oct 2010) →