2011-2016 FJ Cruiser · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. INSTALL REAR BUMPER LOWER COVER

  1. B135151
    Install the 4 screw grommets.

  1. B135150
    Engage the 4 clips and install the rear bumper lower cover.

  1. Tighten the 4 screws.

    Torque:
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf }


2. INSTALL REFLEX REFLECTOR ASSEMBLY LH

  1. B135149
    Install the reflex reflector with the nut.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }


3. INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


4. INSTALL REAR BUMPER PAD LH

  1. B135148
    Engage the 5 claws and install the rear bumper pad.

  1. Install the 5 retainers.


5. INSTALL REAR BUMPER PAD RH

HINT:
Use the same procedure as for the LH side.


6. INSTALL ULTRASONIC SENSOR (w/ Back Sonar)

B135152E01

HINT:
Use the same procedure for both sides.

  1. Install the ultrasonic sensor with the retainer as shown in the illustration.


7. INSTALL FLOOR WIRE (w/ Back Sonar)

B135145E01

HINT:
Use same procedure for both sides.

  1. Connect the ultrasonic sensor connector.

  1. Install the floor wire with the 3 clamps.

← DISASSEMBLY (from Nov 2010)REASSEMBLY (from Nov 2010) →