2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. REMOVE NO. 1 BACK DOOR NAME PLATE

  1. B134740E01
    Apply protective tape to the back door panel in the area around the No. 1 back door name plate.

  1. Using an infrared light, heat the No. 1 back door name plate.

    CAUTION:
    Do not burn yourself with the heated back door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

  1. B134741E01
    Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the No. 1 back door name plate.

  1. Remove the protective tape.


2. REMOVE NO. 2 BACK DOOR NAME PLATE

  1. B134743E01
    Apply protective tape to the back door panel in the area around the No. 2 back door name plate.

  1. Using an infrared light, heat the No. 2 back door name plate.

    CAUTION:
    Do not burn yourself with the heated back door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

  1. B134744E01
    Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the No. 2 back door name plate.

  1. Remove the protective tape.


3. REMOVE REAR NAME PLATE

  1. B134746E01
    Apply protective tape to the back door panel in the area around the rear name plate.

  1. Using an infrared light, heat the rear name plate.

    CAUTION:
    Do not burn yourself with the heated back door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

  1. B134747E01
    Using a gasket scraper with its tip wrapped in protective tape, gradually peel the adhesive surface and remove the rear name plate.

  1. Remove the protective tape.

← COMPONENTS (from Jul 2007)INSTALLATION (from Jul 2007) →