2011-2016 FJ Cruiser · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

  1. B197128
    Engage the 4 clips and install the back door outside garnish.

  1. B190471
    Tighten the 2 nuts.

    Torque:
    6.0 N*m{ 60 kgf*cm , 53 in.*lbf }

  1. B190470
    Connect the back door lock rod.

  1. B135109
    Engage the 4 claws and install the plug hole.

  1. B197126
    Remove the protective tape.


2. INSTALL BACK DOOR SERVICE HOLE COVER

  1. B135108E01
    Install the back door service hole cover.


3. INSTALL BACK DOOR TRIM BOARD

  1. B135554
    Engage the 16 clips and install the back door trim board.

  1. Install the 2 screws.


4. INSTALL BACK DOOR TRIM COVER RH

B139382
  1. Engage the 3 claws and back door trim cover.


5. INSTALL BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as described for the RH side.


6. INSTALL BACK DOOR OUTSIDE MOULDING

  1. B135032
    Install 6 new clips in the positions shown in the illustration.

    NOTICE:
    If you install the clips wrongly, the installation of the back door outside moulding will be improper.

  1. B135031
    Engage the 6 clips and install the back door outside moulding.

  1. B135029E01
    Tighten the screw.

  1. Remove the protective tape.


7. INSTALL SPARE TIRE

Torque:
88 N*m{ 897 kgf*cm , 65 ft.*lbf }

← REMOVAL (from Jul 2007)COMPONENTS (from Jul 2007) →