2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. REMOVE SPARE TIRE

2. REMOVE BACK DOOR OUTSIDE MOULDING

  1. B135029E01
    Apply protective tape to the back door panel in the area around the back door outside moulding.

  1. Remove the screw.

  1. B135030E01
    Using a moulding remover, disengage the 6 clips and remove the back door outside moulding.

  1. B135058E01
    Turn the clips 90° clockwise and remove them.


3. REMOVE BACK DOOR TRIM COVER RH

B139381
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.


4. REMOVE BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as described for the RH side.


5. REMOVE BACK DOOR TRIM BOARD

B135554
  1. Remove the 2 screws.

  1. Disengage the 16 clips and remove the back door trim board.


6. REMOVE BACK DOOR SERVICE HOLE COVER

  1. B135108E01
    Remove the back door service hole cover to the extent that the back door outside garnish can be removed.


7. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY

  1. B197126E01
    Apply protective tape to the back door panel in the area around the back door outside garnish.

  1. B135109
    Using a clip remover, disengage the 4 claws and remove the plug hole.

  1. B190470
    Disconnect the back door lock rod.

  1. B190471
    Remove the 2 nuts.

  1. B197127E01
    Using a moulding remover, disengage the 4 clips and remove the back door outside garnish.

← COMPONENTS (from Jul 2007)INSTALLATION (from Jul 2007) →