2011-2016 FJ Cruiser · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012

HINT:
The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


1. INSTALL QUARTER PANEL MUDGUARD

  1. B135085
    Align the 2 pins of the quarter panel mudguard with the installation hole of the quarter outside moulding.

  1. Install the quarter panel mudguard with the 4 screws.

    Torque:
    5.0 N*m{ 50 kgf*cm , 44 in.*lbf }

  1. Install the clip.


2. INSTALL FRONT FENDER MUDGUARD

  1. B135083
    Align the pin of the front fender mudguard with the installation hole of the front fender moulding.

  1. Install the front fender mudguard with the 5 screws.

    Torque:
    5.0 N*m{ 50 kgf*cm , 44 in.*lbf }

  1. Install the clip.


3. INSTALL REAR BUMPER COVER

  1. B135143
    Engage the 6 claws and the 2 clips and install the rear bumper cover.

  1. B135142
    w/ Back Sonar:

    1. Connect the 2 wire to wire connectors.

  1. B135141
    Tighten the 7 bolts and the 2 screws.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf } for bolt
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf } for screw

  1. B135140
    Remove the protective tape.


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Back Sonar)

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← REMOVAL (from Nov 2012)INSTALLATION (Nov 2010 – Oct 2012) →