INSTALLATION
Removal / installation · Vehicles built Nov 2010 – Oct 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012
- HINT:
- The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. INSTALL QUARTER PANEL MUDGUARD |
Align the 2 pins of the quarter panel mudguard with the installation hole of the quarter outside moulding.

Install the quarter panel mudguard with the 4 screws.
- Torque:
- 5.0 N*m{ 50 kgf*cm , 44 in.*lbf }
Install the clip.
| 2. INSTALL FRONT FENDER MUDGUARD |
Align the pin of the front fender mudguard with the installation hole of the front fender moulding.

Install the front fender mudguard with the 5 screws.
- Torque:
- 5.0 N*m{ 50 kgf*cm , 44 in.*lbf }
Install the clip.
| 3. INSTALL REAR BUMPER COVER |
Engage the 6 claws and the 2 clips and install the rear bumper cover.
Connect the connector.
Connect the clamp and install the floor wire.
- HINT:
- If the vehicle is equipped with back sonar, connect the connector and install the floor wire.
Tighten the 7 bolts and the 2 screws.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf } for bolt
- 3.0 N*m{ 31 kgf*cm , 27 in.*lbf } for screw
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Back Sonar) |
- Torque:
- 3.9 N*m{ 40 kgf*cm , 35 in.*lbf }
