2011-2016 FJ Cruiser · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side (Click here).


3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side (Click here).


4. REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER

HINT:
Use the same procedure as for the RH side (Click here).


5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

  1. B135564
    for Driver Side:

    1. Provisionally install the power window regulator master switch.

  1. for Front Passenger Side:

    1. Provisionally install the power window regulator switch.

  1. Close the door glass.

  1. Disconnect the connector.

  1. Remove the 3 bolts and the outer rear view mirror.

    NOTICE:
    Do not drop or damage the outer rear view mirror when removing the bolts.


6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

  1. B135099E01
    Apply protective tape to the front door panel in the area around the front door glass outer weatherstrip.

  1. B135100E01
    Using a moulding remover, disengage the 8 claws and remove the front door glass outer weatherstrip.


7. REMOVE FRONT DOOR WEATHERSTRIP

HINT:
Use the same procedure as for the RH side (Click here).


8. REMOVE FRONT DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side (Click here).


9. REMOVE FRONT DOOR LOWER FRAME SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side (Click here).


10. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

HINT:
Use the same procedure as for the RH side (Click here).


11. REMOVE FRONT DOOR WINDOW LOWER FRAME

HINT:
Use the same procedure as for the RH side (Click here).


12. REMOVE NO. 1 BLACK OUT TAPE

  1. B135201
    Using an infrared light, heat the No. 1 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.


13. REMOVE NO. 3 BLACK OUT TAPE

  1. B135205
    Using an infrared light, heat the No. 3 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.


14. REMOVE NO. 2 BLACK OUT TAPE

  1. B135203
    Using an infrared light, heat the No. 2 black out tape.

    CAUTION:
    Do not burn yourself with the heated front door panel or infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.

← COMPONENTS (from Jul 2007)INSTALLATION (from Jul 2007) →