2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL BACK DOOR LOCK

  1. B135519E01
    Apply MP grease to the sliding and rotating areas of the back door lock.

  1. Using "Torx" socket wrench T30, install the back door lock with the 3 screws.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Tighten bolt A.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the connector.

  1. B135518
    Connect the back door lock rod as shown in the illustration.


2. INSTALL BACK DOOR LOCK CYLINDER

B135548
  1. Install the back door lock cylinder.

  1. B135547
    Install the retainer, then connect the 2 clamps.


3. INSTALL BACK DOOR SERVICE HOLE COVER

  1. B135595
    Apply butyl tape to the door panel, then install the new back door service hole cover as shown in the illustration.

    HINT:
    1. When installing the service hole cover, pull the links and connectors out through the service hole.
    2. There should be no wrinkles or folds after attaching the service hole cover.
    3. After attaching the service hole cover, check the quality of the seal.


4. INSTALL BACK DOOR TRIM BOARD

  1. B135554
    Engage the 16 clips and install the back door trim board.

  1. Install the 2 screws.


5. INSTALL DOOR TRIM RETAINER CAP

  1. B135553
    Engage the 2 claws and install the door trim retainer cap.


6. INSTALL BACK DOOR TRIM COVER RH

B139382
  1. Engage the 3 claws and back door trim cover.


7. INSTALL BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as for the RH side.


8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSPECTION (from Jul 2007)COMPONENTS (from Jul 2007) →