2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Jul 2007


INSPECT BACK DOOR LOCK

  1. B135520E02
    Check the operation of the back door lock actuator.

    1. Apply battery voltage to the back door lock actuator and check the operation of the back door lock motor.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 1
      Unlocks
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Locks

      If the result is not as specified, replace the back door lock.

  1. Check the resistance of the door lock and unlock switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Door Lock Condition
      Specified Condition
      4 - 5
      Unlocked
      Below 1 Ω
      4 - 5
      Locked
      10 kΩ or higher
      4 - 6
      Unlocked
      10 kΩ or higher
      4 - 6
      Locked
      Below 1 Ω

      If the result is not as specified, replace the back door lock.


INSPECT BACK DOOR LOCK CYLINDER

B140025E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals when the cylinder is operated with a key.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Locked
      Below 1 Ω
      1 - 2
      Unlocked
      10 kΩ or higher
      1 - 3
      Locked
      10 kΩ or higher
      1 - 3
      Unlocked
      Below 1 Ω

      If the result is not as specified, replace the back door lock cylinder.

← REMOVAL (from Jul 2007)INSTALLATION (from Jul 2007) →