2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE BACK DOOR TRIM COVER RH

B139381
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.


3. REMOVE BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as for the RH side.


4. REMOVE DOOR TRIM RETAINER CAP

B135553
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door trim retainer cap.


5. REMOVE BACK DOOR TRIM BOARD

B135554
  1. Remove the 2 screws.

  1. Disengage the 16 clips and remove the back door trim board.


6. REMOVE BACK DOOR SERVICE HOLE COVER

B135544
  1. Remove the back door service hole cover.

    NOTICE:
    Remove any tape remaining on the door side.


7. REMOVE BACK DOOR LOCK

  1. B135517
    Disconnect the back door lock rod as shown in the illustration.

  1. Disconnect the connector.

  1. B135519E01
    Loosen bolt A.

  1. Using "Torx" socket wrench T30, remove the 3 screws and the back door lock.

    NOTICE:
    Do not drop or damage the back door lock when removing the screws.

    HINT:
    Remove the back door lock through the service hole.


8. REMOVE BACK DOOR LOCK CYLINDER

  1. B135546
    Disconnect the connector and the 2 clamps, then remove the retainer.

  1. B135548
    Remove the back door lock cylinder.

← COMPONENTS (from Jul 2007)INSPECTION (from Jul 2007) →