2011-2016 FJ Cruiser · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Jul 2007


1. INSTALL BACK WINDOW LOCK

  1. B135521
    Install the back window lock with the 3 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the connector and clamp.


2. INSTALL BACK DOOR SERVICE HOLE COVER

  1. B135595
    Apply butyl tape to the door panel, then install the new back door service hole cover as shown in the illustration.

    HINT:
    1. When installing the service hole cover, pull the links and connectors out through the service hole.
    2. There should be no wrinkles or folds after attaching the service hole cover.
    3. After attaching the service hole cover, check the quality of the seal.


3. INSTALL BACK DOOR TRIM BOARD

  1. B135554
    Engage the 16 clips and install the back door trim board.

  1. Install the 2 screws.


4. INSTALL DOOR TRIM RETAINER CAP

  1. B135553
    Engage the 2 claws and install the door trim retainer cap.


5. INSTALL BACK DOOR TRIM COVER RH

B139382
  1. Engage the 3 claws and back door trim cover.


6. INSTALL BACK DOOR TRIM COVER LH

HINT:
Use the same procedure as for the RH side.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← INSPECTION (from Jul 2007)PARTS LOCATION (from Jul 2007) →