REMOVAL
Removal / installation · Vehicles built from Jul 2007
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE BACK DOOR TRIM COVER RH
|
 |
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the back door trim cover.
| 3.
REMOVE BACK DOOR TRIM COVER LH |
 |
- HINT:
- Use the same procedure as for the RH side.
| 4.
REMOVE DOOR TRIM RETAINER CAP
|
 |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the door trim retainer cap.
| 5.
REMOVE BACK DOOR TRIM BOARD
|
 |
Remove the 2 screws.
Disengage the 16 clips and remove the back door trim board.
| 6.
REMOVE BACK DOOR SERVICE HOLE COVER
|
 |
Remove the back door service hole cover.
- NOTICE:
- Remove any tape remaining on the door side.
| 7.
REMOVE BACK WINDOW LOCK |
 |
- Disconnect the connector and clamp.
Remove the 3 bolts and the back window lock.