INSTALLATION
Removal / installation · Vehicles built from Aug 2014
| 1. INSTALL CHARCOAL CANISTER ASSEMBLY |
Install the fuel hose to the charcoal canister assembly and slide the hose clip to secure it.
Install the charcoal canister assembly to the vehicle with the 3 bolts.
- Torque:
- 20 N*m{ 204 kgf*cm , 15 ft.*lbf }
Connect the fuel hose to the No. 1 charcoal canister tube and slide the hose clip to secure it.
Engage the clamp to connect the wire harness to the charcoal canister bracket.
Connect the leak detection pump sub-assembly connector.
Connect the No. 2 canister outlet hose sub-assembly to the charcoal canister assembly.

Align the No. 2 canister outlet hose sub-assembly connector with the charcoal canister assembly, then push in the No. 2 canister outlet hose sub-assembly until the retainer makes a "click" sound to connect the No. 2 canister outlet hose sub-assembly to the charcoal canister assembly.
Text in Illustration *1
Nylon Tube
*2
O-ring
*3
No. 2 Canister Outlet Hose Sub-assembly Retainer


Push
- NOTICE:
- Check that there are no scratches or foreign objects on the disconnected parts of the No. 2 canister outlet hose sub-assembly and charcoal canister assembly before performing the work.
- After connecting the No. 2 canister outlet hose sub-assembly, check that the No. 2 canister outlet hose sub-assembly is securely connected by pulling the quick connector.
- Check that there are no scratches or foreign objects on the disconnected parts of the No. 2 canister outlet hose sub-assembly and charcoal canister assembly before performing the work.
Connect the fuel tank vent hose to the charcoal canister assembly.

Align the fuel tank vent hose connector with the charcoal canister assembly, then push in the fuel tank vent hose until the retainer makes a "click" sound to connect the fuel tank vent hose to the charcoal canister assembly.
Text in Illustration *1
Nylon Tube
*2
O-ring
*3
Fuel Tank Vent Hose Retainer


Push
- NOTICE:
- Check that there are no scratches or foreign objects on the disconnected parts of the fuel tank vent hose and charcoal canister assembly before performing the work.
- After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling the quick connector.
- Check that there are no scratches or foreign objects on the disconnected parts of the fuel tank vent hose and charcoal canister assembly before performing the work.
| 2. INSPECT FOR FUEL LEAK |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
- NOTICE:
- Do not start the engine.
Turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed / ON.
Check fuel pump operation.
Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.
