2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2014


INSPECT CHARCOAL CANISTER ASSEMBLY

  1. A282087
    Visually check the charcoal canister assembly.

    1. Visually check the charcoal canister assembly for cracks or damage.
      If cracks or damage are found, replace the charcoal canister assembly.

  1. A282088E01
    Check charcoal canister assembly operation.

    1. With the purge port closed, blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into the vent port, and check that air flows from the air inlet port.

      Text in Illustration 
      *1
      Vent Port
      *2
      Air Inlet Port
      *3
      Purge Port
      *a
      Air
      If the result is not as specified, replace the charcoal canister assembly.

    2. A282089E01
      With the vent port closed, blow 5 kPa (0.1 kgf/cm2, 0.7 psi) of air into the air inlet port, and check that air flows from the purge port.
      Text in Illustration 
      *1
      Vent Port
      *2
      Air Inlet Port
      *3
      Purge Port
      *a
      Air
      If the result is not as specified, replace the charcoal canister assembly.

  1. A282090E02
    Check for air leaks.

    1. Connect a pressure gauge to the vent port of the charcoal canister assembly.

      Text in Illustration 
      *1
      Vent Port
      *2
      Air Inlet Port
      *3
      Purge Port
      *a
      Pressure Gauge

    2. With the purge port and the air inlet port closed, apply 20 kPa (0.2 kgf/cm2, 2.8 psi) of pressurized air into the vent port, then confirm that pressure is retained for 1 minute.
      If the result is not as specified, replace the charcoal canister assembly.

← REMOVAL (from Aug 2014)INSTALLATION (from Aug 2014) →