ON-VEHICLE CLEANING
Removal / installation · Vehicles built Jul 2007 – Jul 2009
| 1. CHECK FIN FOR BLOCKAGE |
![]() ![]() |
If the fins are clogged, wash them with water or a steam cleaner, then dry them with compressed air.
- NOTICE:
- If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so keep to the following injection distances.
Injection Pressure
kPa (kgf*cm2, psi)
Injection Distance
mm (in.)
2,942 to 4,903
(30 to 50, 427 to 711)
300 (11.811)
4,903 to 7,845
(50 to 80, 711 to 1,138)
500 (19.685)
- If the fins are bent, straighten them with a screwdriver or pliers.
- Do not expose electronic components to water.
- If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so keep to the following injection distances.


