2011-2016 FJ Cruiser · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Jul 2009


1. INSTALL RADIATOR TANK UPPER

G036195E02
  1. Install a new radiator tank.

  1. Tap the core plate with a soft-faced hammer until there is no gap between the core plate and radiator tank.


2. REMOVE RADIATOR TANK LOWER

HINT:
Perform the same procedures as for the radiator tank upper.


3. ASSEMBLE SST

A087090E05
SST
09230-01010   (09231-01010, 09231-01020)
  1. Install the punch assembly into the overhaul handle by inserting it into the hole in part A as shown in the illustration.

  1. While gripping the handle, adjust the stopper bolt so that dimension B is as shown in the illustration.

    Dimension B:
    8.4 mm (0.331 in.)


4. CAULK CORE PLATE

  1. Lightly press SST against the core plate in the order shown in the illustration. After repeating this a few times, fully caulk the core plate by gripping the handle until stopped by the stopper bolt.

    A129875E01

    SST
    09230-01010   (09231-01010, 09231-01020)

    HINT:
    Do not tap the portions indicated in the illustration or the oil cooler using SST. Use pliers or a similar tool. Do not damage the core plate.

  1. G036194E01
    Check the core plate height (H) after completing the caulking.

    Plate height (H):
    8.7 to 9.1 mm (0.343 to 0.358 in.)

    If the height is not as specified, readjust the stopper bolt of the handle, then caulk it again.


5. INSTALL RADIATOR DRAIN COCK PLUG
  1. Install a new O-ring onto the drain cock plug.

  1. Install the drain cock plug.

← INSPECTION (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →